Humminbird Side Imaging Forums
General => General Discussion => Topic started by: captainbrad on May 02, 2014, 09:43:29 PM
-
I am just setting up a new boat for this year. I decided to go with a trolling motor mount 360 but want to make it a transom mount. The reason is my tunnel hull jon boat has float pods and there is only about 5" of room between the motor and the float pods. A transom mount if it would even fit would be very tight. Also I don't have a trolling motor on this boat because it is a catfish boat used specifically for anchoring.
My question is has anyone built a bracket that will pivot or slide to manually deplay a trolling mount 360? I am looking for design ideas and suggestions.
Thank you