Humminbird Side Imaging Forums
Side Imaging Forums => Helix Series Units => Topic started by: Apook89 on February 19, 2018, 05:53:33 AM
-
Hi, I need some help. when I'm in shallow water I have problems with visualization both in the side and down vision. can someone help me? I own a HELIX 9X CHIRP SI GPS G2N transducer XM 9 20 MSI T. PLACE SOME PICTURES. I apologize for my english not perfect :)
-
Have you tried Restore Defaults ...??
Is there another unit running at the same time ...??
Do you have any screenshots in deeper water ...??
Rickie
-
When I first had my Helix 9 mega I thought that I was smarter than the unit. Started making all kinds of adjustments, well I can say I thought that I just ruined my picture. I did a reset default and have left it a lone. The images I am getting are GGGGGREAT. But I did spend a lot of time just going around looking at the bottom.
-
Is there another Sonar unit on the vessel operating at the same time ...??
Is there a trolling operating at the same time ...??
Rickie
-
hi, there's no other unit on board.
-
Some of the examples looks like some kind of electrical interference ... and some don't ...
Do you have access to someone that you could test their head unit on your xducer ...??
Rickie
-
Rickie
In this image, ( first in group ), is the SI range set at 1 1/2 the depth? If so, that might explain that image.
Mike
I can't move the image here, so this is the post I'm talking about.
Re: help HELIX 9 CHIRP MEGA SI GPS G2N
« Reply #3 on: April 23, 2018, 03:46:41 AM »
QuoteModifyRemoveSplit Topic
hi, after several problems I managed to make some screens of the problem. Thank you. The Helix has also been reset, but the problem persists.
Thank you again
-
I'm thinking the xducer is bad ...
Cross-testing with another head unit or xducer can verify ...
Rickie
-
I'm sure you are more correct than my long shot guess. The divide and conquer technique is a good choice.
Mike
-
I reset the unit. disassembled the transducer and mounted in the test tank at home, but the problem persists. I also noticed that the transducer makes a slight noise, a light pop-up is normal? the 2d vision works well, but the side and down vision have the problems described. Help
-
If you do not have access to a other xducer to test - you will need to contact your Humminbird distributor or dealer ...
You can also contact Humminbird in Eufaula Alabama here ...
https://www.humminbird.com/Category/Company/Contact-Us/ (https://www.humminbird.com/Category/Company/Contact-Us/)
Rickie