Humminbird Side Imaging Forums

General => General Discussion => Topic started by: johnmr12 on April 15, 2015, 11:05:21 PM

Title: Base layer setting
Post by: johnmr12 on April 15, 2015, 11:05:21 PM

Every time I power up my 898, the base layer setting in the chart view is default. I have to change it to AC so I can see my auto chart map. Does anyone know how to set the base layer so it stays in AC mode and I don't have to change it every time?

Title: Re: Base layer setting
Post by: Goosedwnr on April 16, 2015, 02:24:29 PM

I have had the same question. I too have to switch it every time. I have not found anything that covers this issue.

So there are at least 2 of us!

-Cory

Title: Re: Base layer setting
Post by: CamoHunter on April 16, 2015, 05:16:38 PM

Leave it on  ;)

Nope, I wasn't aware that a person had to do that each time they powered up the unit.