I will try to post a pic of my transom when my boat is out of the shop. Impellar went and enginge overheaeted, what a mess. The hull is a deep v
i have tried the transducer on both port and starboard side of transom. It is mounted right now 15 inches fro prop. at low speeds (less than 7mph) i am unable to get a reading on side imaging on the side towards the prop. The transducer is just barely below the lowest point on the lower unit. I am unable to mount any lower without getting closer to the prop. when is am running at about 10mph it works fine. am i getting cavitation from prop causing me to loose signal on the one side. I should say that on the side towards the prop i do get a small amount of imaging on screen and then the rest is unreadable. (if that make sense).. I saw that humminbird has a splitter for the transducer cable, can i run 2 transducers with one on either side.