Side Imaging Forums > Onix and Ion Series
ONIX10 NT Mega SI transducer?
breakline11@gmail.com:
ONIX 10 NT software 3.35 back to factory reset
Had this unit running 360 and 2D for the last year.
Added the XM14 20 Msi T Mega SI transducer. 2D and DI work but no SI.
Unit is not showing a source for the SI.
Any help?
danlaboucane:
did you try to turn off 360 on the onix ? if still on the 360 shuts off any SI i think .
breakline11@gmail.com:
When I reset the unit the 360 source option was gone.
Still no SI option though.
Maybe a hard reset?
Thanks
danlaboucane:
not shure , lets see who will chime in .
rnvinc:
Disconnect the 360, connect just the XM 14 20 MSI T, Restore Defaults and test ...
Rickie
Navigation
[0] Message Index
[#] Next page
Go to full version