Humminbird Side Imaging Forums
Side Imaging Forums => Onix and Ion Series => Topic started by: breakline11@gmail.com on December 03, 2020, 02:26:38 AM
-
ONIX 10 NT software 3.35 back to factory reset
Had this unit running 360 and 2D for the last year.
Added the XM14 20 Msi T Mega SI transducer. 2D and DI work but no SI.
Unit is not showing a source for the SI.
Any help?
-
did you try to turn off 360 on the onix ? if still on the 360 shuts off any SI i think .
-
When I reset the unit the 360 source option was gone.
Still no SI option though.
Maybe a hard reset?
Thanks
-
not shure , lets see who will chime in .
-
Disconnect the 360, connect just the XM 14 20 MSI T, Restore Defaults and test ...
Rickie
-
I disconnected the 360. I only have power and the XM transducer plugged in. I restored unit to factory default. Still only 2D and DI. I can't find a transducer manual selection option. The unit automatically recognized the XM but not all 3 capabilities.
-
Update: HB tech says XM transducer is only going to give me 2D capabilities. I told her it was already giving me 2D and DI, but she insisted it was only for 2D. I stopped arguing.
Further discussion she told me the unit would not do SI no matter what transducer I use.
Back to drawing board.
-
ok , got me ! i always thought you had an SI unit ! my mistake but i saw a lot of places you can get DI with an di ducer , even HUMMINGBIRD told me so ! but unless you have a SM3000 you cannot get SI , sorry
-
Update: HB tech says XM transducer is only going to give me 2D capabilities. I told her it was already giving me 2D and DI, but she insisted it was only for 2D. I stopped arguing.
Further discussion she told me the unit would not do SI no matter what transducer I use.
Back to drawing board.
I had read your original post as an ONIX 10 SI NT ... duh
Seems I do remember the ONIX (Sonar only) could get DI with a DI capable xducer ...
Rickie