Humminbird Side Imaging Forums

Side Imaging Forums => 898c SI => Topic started by: tgordon on July 07, 2013, 08:20:35 PM

Title: 898 HD SI. No network tab after update
Post by: tgordon on July 07, 2013, 08:20:35 PM

I updated my 898 HD SI with the new software on my account. I also have a 788 HD DI that I updated too. Now I have no  network tab in settings to show the two linked together. I have them linked with an Ethernet cable. No tab on either unit

Any thoughts?

Thanks,
Terry Gordon

Title: Re: 898 HD SI. No network tab after update
Post by: lcookie on July 07, 2013, 09:59:26 PM

Try this.  Disconnect cable from both units, reset defaults, and power units down.  Then power them up and reconnect the cable after they are up and running.  If it still does not do it power them down with the cable connected and power them back up.  Should be there after that.  Use to have this issue with my interlink.  Only happened once with ethernet.

Title: Re: 898 HD SI. No network tab after update
Post by: tgordon on July 12, 2013, 09:07:35 PM

Thank you! That worked.

Terry G.