Side Imaging Forums > 797c SI

797 c2 Waiting on Test Command


Shotgun Slim:
After my unit runs for 10-15 minutes I get a "Waiting for Test Command " prompt.  How to I fix this.  My unit just came back from factory less than a year ago and I have used it very little since then.  Please don't say I will be charged again.  Thanks

I would try deleting all waypoints, routes and tracks and remove any memory cards to see if this happens again or not.
Otherwise, call the Humminbird Customer Service folks at 1-800-633-1468

In addition to Greg's advice ...

The 1 time my 1197 showed this "Waiting on test command" ... My battery was bad and would not hold a charge ...

You might load test the battery just to make sure you have ample power supply ...



[0] Message Index

Go to full version