Side Imaging Forums > Onix and Ion Series
ONIX10 NT Mega SI transducer?
breakline11@gmail.com:
I disconnected the 360. I only have power and the XM transducer plugged in. I restored unit to factory default. Still only 2D and DI. I can't find a transducer manual selection option. The unit automatically recognized the XM but not all 3 capabilities.
breakline11@gmail.com:
Update: HB tech says XM transducer is only going to give me 2D capabilities. I told her it was already giving me 2D and DI, but she insisted it was only for 2D. I stopped arguing.
Further discussion she told me the unit would not do SI no matter what transducer I use.
Back to drawing board.
danlaboucane:
ok , got me ! i always thought you had an SI unit ! my mistake but i saw a lot of places you can get DI with an di ducer , even HUMMINGBIRD told me so ! but unless you have a SM3000 you cannot get SI , sorry
rnvinc:
--- Quote from: breakline11@gmail.com on December 04, 2020, 11:30:07 AM ---Update: HB tech says XM transducer is only going to give me 2D capabilities. I told her it was already giving me 2D and DI, but she insisted it was only for 2D. I stopped arguing.
Further discussion she told me the unit would not do SI no matter what transducer I use.
Back to drawing board.
--- End quote ---
I had read your original post as an ONIX 10 SI NT ... duh
Seems I do remember the ONIX (Sonar only) could get DI with a DI capable xducer ...
Rickie
Navigation
[0] Message Index
[*] Previous page
Go to full version