Humminbird Side Imaging Forums
General => General Discussion => Topic started by: Blove WI on February 28, 2017, 11:25:01 AM
-
Hello
I have a broken pin on my transducer - the transducer is the Xhs 9 hdsi 180t, it is the single pin towards the bottom of the plug. Does anyone know what this pin is for and if there is a way to fix it instead of having to spend $200 for a new transducer?
Thanks for the help
Bryan
-
hi
it's the left side, to repare, buy a transducer extension cāble accessory, cut transducer cable and cut extension, solder wire isolate them and it's ok.
it's not hard job.
good luck
-
Good solution.
-
Thanks for the suggestion. I will try splicing
-
I am having trouble identifying which extension works for the XHS 9 HDSI 180T transducer. Does anyone know the part number for the extension?
-
EC W XX where xx = the length.... e.g EC W 10
-
Thank you!!!