Humminbird Side Imaging Forums

Side Imaging Forums => Onix and Ion Series => Topic started by: fotoguy on May 10, 2015, 08:38:14 PM

Title: ONIX Software Update
Post by: fotoguy on May 10, 2015, 08:38:14 PM

Updated my ONIX to the new version 2.30, it updated just fine the only thing so far is when I am moving no matter if it is slow are fast the depth reading is off the charts.
Screen shots below:

Title: Re: ONIX Software Update
Post by: Trytoofish on May 10, 2015, 08:52:40 PM

I would check your transducer selection and frequency selected. It acts like you have no transducer connected or selected. I have seen depth jump around a bit on mine but only in shallow water. And switching max depth from auto to a depth a little deeper than i'm in, fixes that.after updating, if you restored defaults some of the selections change.

Title: Re: ONIX Software Update
Post by: g dog on June 05, 2015, 12:17:54 AM

Mine is doing the exact same thing.  Did you find a solution?

Title: Re: ONIX Software Update
Post by: fotoguy on June 05, 2015, 06:24:28 PM

No, I did not fine a solution

Title: Re: ONIX Software Update
Post by: brisner on June 11, 2015, 11:37:38 AM

Same here looks like another patch needed. Mine has been back to Humminbird four times now and need to go back again! Mine won't save data when recording after the last update.Okay

Title: Re: ONIX Software Update
Post by: fotoguy on July 09, 2015, 06:16:49 PM

Has anyone else had this problem?

Title: Re: ONIX Software Update
Post by: brisner on July 09, 2015, 09:34:08 PM

I had two units running at the same time one was my Onix and the other a 859 Sonar / GPS unit on sonar at the same time and got the high depth reading. Now when I run I shut off the sonar on one of the units. Power button, Sonar - Off. That fixed mine.