Humminbird Side Imaging Forums

Side Imaging Forums => Solix => Topic started by: jimf on October 24, 2022, 09:15:42 PM

Title: solix 12 G3 Mega+ side image wave lines
Post by: jimf on October 24, 2022, 09:15:42 PM

I get this white wave lines on the left side of Mega+ Its doesn't show up on 800 Khz or 455 Khz. Only on the Mega+ I have a picture attached. I was thinking try to set the sharpens ?

Title: Re: solix 12 G3 Mega+ side image wave lines
Post by: jimf on October 25, 2022, 01:42:59 PM

What i did I turned the SI Sensitivity offset to -7 and the white wave lines went off the screen. If i turn the SI sensitivity offset the opposite way to say 6 or 7 the white wave lines come very close to the central of the screen.
Looks like if I turn SI sensitivity offset to -7 it gos away.

Is that what the SI Sensitivity offset is for ? Because it worked BUT i will see what it really looks like on the water when I go out again.

JIM

Title: Re: solix 12 G3 Mega+ side image wave lines
Post by: rnvinc on October 25, 2022, 09:18:31 PM

“SI Sensitivity offset” adjusts the left panel of the SI view if that left SI view is consistently brighter or darker than the right SI panel  ...

If there is not another unit running the same frequency (which can cause crosstalk interference) - try Sonar Restore Defaults or full Restore Defaults  ...

Rickie