I booted up after I put the boat in the water yesterday and headed out. I noticed that I wasn't reading my speed and in it's place was the water temp. When I got to my fishing spot I put the trolling motor down and the 360 down. I was able to read my speed on the trolling motor remote. I shut everything down and rebooted everything. I now reset my views and I now had my speed reading. Before I rebooted I looked for my menu to set my views and it was not there. After rebooting I was able to find the menu and reset everything. A little while later I lost my speed view and it reverted back to water temp I also noted that there was a time when the depth reading went crazy. I had it set for auto and the depth showed 90 feet when I was in 7 feet. This screwed up my mapping. Is there a way where I can go in to eliminate the reading of 90 feet? I really hate to loose 5 hours of mapping because if this problem. I am using the following software, i-pilot link--1.160, 360--2.00, 1198--6.740
Any help and or suggestions will be greatly appreciated
Phil