Humminbird Side Imaging Forums

General => General Discussion => Topic started by: steelebob on November 13, 2013, 03:01:26 PM

Title: Don't see SET SIMULATION POSITION
Post by: steelebob on November 13, 2013, 03:01:26 PM
I can't bring up the SET SIMULATION POSITION option when I'm in the sim mode. I have the navionics card in. I also don't always see the map of a lake I know exists (when I'm fishing), when I'm trying to edit data at my home.
Title: Re: Don't see SET SIMULATION POSITION
Post by: RGecy on November 13, 2013, 09:11:31 PM
Are you in Advanced Settings Mode?  I haven't checked on new softwares, but should be there.
Title: Re: Don't see SET SIMULATION POSITION
Post by: Humminbird_Greg on November 14, 2013, 12:25:11 PM
You are correct Robert; the Set Simulation Position menu will not be shown unless the User Mode menu setting is on “Advanced”.

Not sure why you would not always see the make map.  Can you give us a little more detail on what you are doing when the map disappears.
Is the lake actually on the Navionics mapping card?
Which mapping card (including year model) do you have?
Do you have another mapping card in the unit at the same time?
What is the Chart Select menu setting?
Title: Re: Don't see SET SIMULATION POSITION
Post by: steelebob on November 14, 2013, 01:33:30 PM
I didn't realize that the Advanced Setting had been changed.

 So now I have 2 898c. Both navionics cards work fine on one unit but not on the other unit in sim mode.
Title: Re: Don't see SET SIMULATION POSITION
Post by: Humminbird_Greg on November 15, 2013, 02:55:22 PM
Do they work okay in that unit when it is running on your boat on the water?
Title: Re: Don't see SET SIMULATION POSITION
Post by: steelebob on November 15, 2013, 03:14:04 PM
Yea, I was going to mention that.
Title: Re: Don't see SET SIMULATION POSITION
Post by: Humminbird_Greg on November 15, 2013, 03:26:01 PM
Hmmm, I am out of ideas on this one.

SimplePortal 2.3.3 © 2008-2010, SimplePortal