Humminbird Side Imaging Forums
General => General Discussion => Topic started by: johnmr12 on April 15, 2015, 11:05:21 PM
-
Every time I power up my 898, the base layer setting in the chart view is default. I have to change it to AC so I can see my auto chart map. Does anyone know how to set the base layer so it stays in AC mode and I don't have to change it every time?
-
I have had the same question. I too have to switch it every time. I have not found anything that covers this issue.
So there are at least 2 of us!
-Cory
-
Leave it on ;)
Nope, I wasn't aware that a person had to do that each time they powered up the unit.