Hi,
I had an issue once before and was happy with the support I got on the forums. I am having a problem that I think should be easy to fix, but I am not sure what to do. I use to have a an 1198CSI at my console linked to a 898CSI at my trolling motor. Both units had separate transducers and gps receivers. I now installed another 898CSI by my trolling motor and linked all 3 units with a 5 port ethernet switch. The 2 original units are working, but the unit I just installed was stuck in demonstration mode. I think it said no transducer detected. I got it out of demonstration mode, but I can't use the sonar or map. I did not install a transducer or gps receiver for the new unit. I figured I would be able to plug it in and use information from one of the 2 transducers I have installed or I thought I would be able to use the map from one of the other unit gps receivers. I'm sure it is just a simple settings change, but I do not know what settings to change. I played around with the settings for a while, but did not make any progress.
Thank you!