Humminbird Side Imaging Forums
General => General Discussion => Topic started by: Bigtiny on June 20, 2019, 10:06:42 PM
-
I have Solix 15 at dash . Helix 12 at trolling motor Ethernet together. I added a 360 and installed it at Ethernet port but it will show good at Solix but at helix it will lose signal after 5 mins. On the phone with huminbird and they tell me that u can’t share images through the Ethernet.they advised me to unplug the helix from Ethernet and run 360 straight to helix. After doing that it runs fine on helix. However now the helix is disconnected from Ethernet I can’t share waypoints. There has to be some settings that I don’t have right.Please advise
-
Please post the same HB info you posted at Crappie.com ...
It may help someone here also ...
Rickie
-
i got up this morning since I was off and what do you know it’s working . Best I can figure I have a bad port in my Ethernet box. All I did after a conversation with Wayne p is to move the connections to a different port on Ethernet. Thanks to everyone on this forum for Input and special shot out to Wayne,Rickie. And FYI even according to huminbird site you can share 360 imaging between solix and helix. Below is literature from huminbird site.
When networked together via Ethernet, HELIX and SOLIX models will share:
Waypoints, Tracks & Routes
GPS signal (not mapping)
i-Pilot Link information and control
360 Imaging
Humminbird CHIRP radar
Bluetooth Talon control**
NMEA 2000 network information
*Depending on technology built into each networked fish finder, some sonar images may not be shared if unable to be supported by your unit’s software. Ensure that you are running the latest software by finding updates here: https://www.humminbird.com/support/software-updates (https://www.humminbird.com/support/software-updates)
See full compatibility of networking and sonar information here: https://www.humminbird.com/support/f...etSonarSharing (https://www.humminbird.com/support/f...etSonarSharing)
**If both HELIX and SOLIX are on the network and need control of Bluetooth TALONs then at least one SOLIX and one HELIX G2N/G3N must be paired to the Bluetooth TALON at the same time.