Author Topic: custom 360 imaging TM mount  (Read 3633 times)

0 Members and 1 Guest are viewing this topic.

Offline SgtPalm1

  • Newbie
  • *
  • Joined: Jul 2015
  • Location: florida
  • Posts: 1
  • Unit(s): onix 10ci si
  • Software: 2.30
  • Accessories: as 360 tm
custom 360 imaging TM mount
« on: July 13, 2015, 06:08:54 PM »
I have been on just about every forum to find a way to mount the 360 where I could remove it easily if needed. There is a wealth of knowledge out here so I thought I would add my solution to the bow mount 360. I took an old evinrude trolling motor mount, rebuilt it. It was the smallest flip down locking mount I could find and it had a sleeve that was 1.5" so a sheet of cork cut to size worked well to take up the gap.


Thanks for all the posts. I also found the fix for the 360 not being recognized by the onix. Older 360 will not update on new onix with 2.30.



Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo

 

Related Topics

  Subject / Started by Replies Last post
22 Replies
16758 Views
Last post March 11, 2014, 11:34:50 AM
by bgump24
0 Replies
3681 Views
Last post September 14, 2011, 08:03:43 PM
by gup72
6 Replies
6436 Views
Last post March 05, 2012, 07:51:33 AM
by Blackwaterkatz
1 Replies
3614 Views
Last post April 30, 2012, 10:07:28 AM
by Shooter00
26 Replies
16572 Views
Last post May 05, 2014, 04:07:57 PM
by newkid4si
3 Replies
5368 Views
Last post March 11, 2014, 04:46:31 PM
by Humminbird_Greg
15 Replies
19970 Views
Last post December 21, 2015, 11:04:14 AM
by Archie
6 Replies
5288 Views
Last post March 17, 2017, 07:47:49 PM
by Boots


SimplePortal 2.3.3 © 2008-2010, SimplePortal