Humminbird Side Imaging Forums
Other Humminbird Products => Accessories => Topic started by: blasir on December 16, 2018, 07:42:33 PM
-
Hello.
I have a question I recently bought a helix 9si gn2. I'm very disappointed because i discovered cannonlink is not supported anymore by the new hb series and I still have in my garage 2 canno mag 20 tournament with cannonlink module and a 998si from my previous boat. I would like to use the cannonlink in the new boat but I dont wanna install another xducer. My question is....
Can I use my helix connected with its own ducer to send depth data to a networked 998 and use this 998 monitor as cannonlink controller to manage my downriggers?
Regards
Raoul
-
HELIX G2N can network fixed frequency SI and 2d to 998 when CHIRP is shut off the HELIX G2N (in the CHIRP Configuration Menu under the Setup tab) ...
https://www.humminbird.com/sites/humminbird_site/files/transducer_support_grid_v10_0.pdf (https://www.humminbird.com/sites/humminbird_site/files/transducer_support_grid_v10_0.pdf)
I have no info on CannonLink ... You might call HB with that question ...
1-800-633-1468
Rickie
-
HELIX G2N can network fixed frequency SI and 2d to 998 when CHIRP is shut off the HELIX G2N (in the CHIRP Configuration Menu under the Setup tab) ...
https://www.humminbird.com/sites/humminbird_site/files/transducer_support_grid_v10_0.pdf (https://www.humminbird.com/sites/humminbird_site/files/transducer_support_grid_v10_0.pdf)
I have no info on CannonLink ... You might call HB with that question ...
1-800-633-1468
Rickie
Hello.
I have a question I recently bought a helix 9si gn2. I'm very disappointed because i discovered cannonlink is not supported anymore by the new hb series and I still have in my garage 2 canno mag 20 tournament with cannonlink module and a 998si from my previous boat. I would like to use the cannonlink in the new boat but I dont wanna install another xducer. My question is....
Can I use my helix connected with its own ducer to send depth data to a networked 998 and use this 998 monitor as cannonlink controller to manage my downriggers?
Regards
Raoul
I would imagine that would work. I have a similar issue but have canonlink via my 997 which I cant network. I have both transducers installed and my Helix 10 G2N ans 997 SI running, but they cant run simultaneously since the 997 transducers interefers with the Helix