Humminbird Side Imaging Forums

Side Imaging Forums => Helix Series Units => Topic started by: gaj on August 03, 2018, 11:41:29 AM

Title: helix to ipilot linkc
Post by: gaj on August 03, 2018, 11:41:29 AM
Can I use a spliter cable on my helix 10si to ultrex ipilot link ? already have Ethernet cable run to another helix10 at console
Title: Re: helix to ipilot linkc
Post by: rnvinc on August 03, 2018, 12:54:47 PM
HB does not make an Ethernet "splitter" cable  ...

*You will need an AS EC QDE adapter cable for each HELIX  ...  http://www.humminbird.com/Products/AS-EC-QDE/ (http://www.humminbird.com/Products/AS-EC-QDE/) 
*You will need AS ETH 5XPG Ethernet switch  ...  http://www.humminbird.com/Products/AS-EC-QDE/ (http://www.humminbird.com/Products/AS-EC-QDE/) 

The AS ETH 5XPG requires 12v power so plan it's installation  ...   

*Then you will need an Ethernet cable for each HELIX long enough to reach the AS ETH 5XPG switch  ... http://www.humminbird.com/Freshwater/Product-Category/Accessories/Cables/?facets=7319, (http://www.humminbird.com/Freshwater/Product-Category/Accessories/Cables/?facets=7319,) 

The iLink should have come with an Ethernet cable to reach the AS ETH 5XPG switch   ...   

Rickie
SimplePortal 2.3.3 © 2008-2010, SimplePortal