Side Imaging Forums > Helix Series Units
networking two Helix's
Tjo:
I'm just looking for confirmation on how I want to setup my boat. I currently have the following setup.
Bow
899hd ci
Minnkota Ulterra with IPilot link
Hummingbird 5 port switch.
Divers seat
Helix 10 Mega SI G2N
Left and right splitter cable (9 M SILR Y)
Dual splitter for high speed and SI (9 M SIDB Y)
Transom
2 Mega SI transducers (XM 9 20 MSI T) (left and right)
High speed transducer (XNT 9 SI 180 T)
What I plan on buying is a Helix 12 Chirp GPS G2N and mount it in driver area and move the Helix 10 Mega SI G2n to bow and remove the 899.
My Questions.
Will i need to move all the cabling and splitters to the bow with the helix 10 or can I hook them up to the Helix 12
Will this allow me to have all the features of Mega SI at both positions?
Thank you for your help.
Cheers Tom
rnvinc:
You can use the same Y cable Setup on the transom for the HELIX 12 MEGA ...
HELIX G2N can share waypoints, accessories and all Sonar to another HELIX G2N ...
Rickie
Tjo:
Thanks Rickie.
Tjo:
Currently I have all the transducer on the Helix 10 Mega SI when I move that one to the bow and put the new Helix12 GPS G2N in the driver area do I need to move the cabling to the front with the Helix 10?
rnvinc:
HELIX 12 CHIRP MEGA SI G2N can use the same cabling and xducers that your HELIX 10 CHIRP MEGA SI G2N is currently using at the console/transom ...
Rickie
Navigation
[0] Message Index
[#] Next page
Go to full version