Side Imaging Forums > Helix Series Units

New HELIX 9 CHIRP MEGA SI GPS G2N owner / transducer location suggestions

(1/1)

pdorman:
Would like suggestions as to where to install the transducer, just purchased a 4 x12 transducer mounting plate to install also.  Thanks in advance.

rnvinc:
The mounting board already on the transom would be a good start as long as there's no rib directly in front of the xducer  ...

Rickie

FishinLite:
I think the current one is a little close to the outboard. Here is the location of mine.

I currently have a SI HD transducer located in the show location. Connected to a Helix 9. I need to tilt the motor up a little but not out of the water.

I now a have a 360 mounted on the left side opposite the HD transducer.

D Johnson:
with the OB trimmer all the way it and turned all the way that way hold the transducer there and check that the OB won't touch it in a hard turn.  You won't have to trim out much for to see to port.  I seldom run with the ob trimmed all the way in.  Don

sfw1960:
http://forums.sideimagingsoft.com/index.php?topic=9962.0

Navigation

[0] Message Index