Humminbird Side Imaging Forums
Side Imaging Forums => 1197c SI, 1198c SI & 1199ci HD SI => Topic started by: Bob Lammon on July 26, 2014, 03:25:30 PM
-
Hi, I have 2 898c si combos with I pilot link. I down loaded 7.090. Now when I pilot is connecting it shuts off units. Fish finders work when not connected. I also tried downloading older updated sand they do not even register when I put sad card in unit. Please help as this is a lot of money to me and I am so flustered. Thank you for reading
-
HB Greg should have a suggestion/answer for you. Probably be here Monday sometime depending on work schedule.
Mike
-
Did you resetting all defaults after the update? If not, worth a try.
-
Yeah I reset them. I'm thinking when I did the update the I pilot was not on or connected yet to fish finder as far as communicating.
-
I replied on your pm Bob. Not sure why the older software would not be recognized by the unit. I assume you used the same SD card that you used to update the 898 units with, correct? Maybe try fully formatting the SD card and re-downloading the software to try it again. I really think though that you should work with the Humminbird Customer Center (CRC) folks on this though as I have read where there were different things needed to get the iPilot Link Controller and Remote to update their software.