Image

«
 
»
'11 nitro z-6 997c s… '11 nitro z-6 997c s… '11 nitro z-6 997c s… '11 nitro z-6 997c s… '11 nitro z-6 997c s…
'11 nitro z-6 997c si install
Click the picture to view full size.
2011 Z-6 Nitro, the ram mount base wouldnt mount up very well due to the difference in height between the console and the actual side of the boat. I ended up taking the arm off the base, drilling one hole and installing a large washer . I used the bolt that came in the arm and put it up through the whole I drilled from the bottom. I installed the rubber next , then the arm finishing off the with the quick connect threaded top that came on the arm. It all worked nicely,  it also retained its swivel motion.

Poster information

Item Info

Neverenuff

  • Total Items: 8
  • Total Comments: 0
PostedDecember 10, 2011, 10:41:55 PM
Width × Height1200 × 900
Filesize244 KB
Filenamesecuredownload[2] (5).jpg
Views1506
Rating
Last EditedDecember 10, 2011, 10:56:30 PM
BBC embed code
HTML embed code
Direct link
Comments No comments
Aeva Media 1.4w © 2008-2011 Nao & Dragooon - Wedge: level up your forum!

anything
SimplePortal 2.3.3 © 2008-2010, SimplePortal