Humminbird Side Imaging Forums
General => General Discussion => Topic started by: metalworx on March 22, 2015, 08:54:21 AM
-
This is for Humminbird Greg. I currently run two 1198's networked together with ethernet. I'm also running a as gps hs antenna and a tg w (think that's correct) temp probe in livewell. If I switch to two Onix NT 10 SI units, can you tell me what all I will need for this new setup. Thank you for your time! Also, will older Navionics premium east map cards run in these units?
metalworx
-
You will need the ONIX power cord with the temp/speed connector for livewell monitor and the ONIX GPS/nema cord to attach HS puck. Ethernet cable is the same. Navionics chip should work. Everything else should come with the units.
-
100% correct lcookie. ;D
The PC-12-ST Power Cable will allow you to connect the TG-W to your new ONIX 10 NT SI unit and the AS-GPS-NMEA will allow you to connect the GPS-HS GPS Receiver (with Heading Sensor). The Navionics Premium mapping cards will work as well.
-
Thanks guys for the info!
Metalworx