Humminbird Side Imaging Forums

Side Imaging Forums => Helix Series Units => Topic started by: chaley1964 on April 29, 2020, 09:48:06 AM

Title: Networked GN3 Helix 10 does not show follow the contour
Post by: chaley1964 on April 29, 2020, 09:48:06 AM
So I have a ulterra networked with my 9 on the bow and my 10 on the console.  Neither show FTC when I click on a contour line and hit "go to".  I had it back at the dealer yesterday that I bought it from and they couldn't figure it out.  We are scheduled to put it in the water tonight and he is going to call HB while on the water.  I thought I would throw this out here to see if anybody had the same issue.  These units were brand new last spring and are on a Lund Impact 2025.
Title: Re: Networked GN3 Helix 10 does not show follow the contour
Post by: rnvinc on April 30, 2020, 08:18:35 AM
I have read reports that sometimes zooming the map closer and then placing the cursor on the contour line will allow the selection  ...

Rickie
SimplePortal 2.3.3 © 2008-2010, SimplePortal