Humminbird Side Imaging Forums

Side Imaging Forums => 898c SI => Topic started by: TazzMan on March 02, 2011, 06:41:46 AM

Title: How to set the map offset
Post by: TazzMan on March 02, 2011, 06:41:46 AM

I have tried to to use the map offset.  I know there is a way to set the depth offset.  If the lake water is lower or higher than when the map was made then the depth lines on the map are not correct. I set my unit to highlight 20ft and the water is only 16ft.  I have a navonics card for my area.   I set the offset like it says but noght seems to change and the depth lines same the same.  maybe I am doing something wrong.   please advise!!! 

Title: Re: How to set the map offset
Post by: RGecy on March 02, 2011, 02:58:28 PM

Tazzman,

I think that is only available for the Lakemaster Charts.

http://forums.sideimagingsoft.com/index.php?topic=1190.0 (http://forums.sideimagingsoft.com/index.php?topic=1190.0)

Robert

Title: Re: How to set the map offset
Post by: stillbear on March 03, 2011, 06:43:47 AM

Tazzman I think you are talking about shaded depth that is what Navionics at this time has.
Lake Master has water offset it is exclusively made for HB. I use both.